3D-printed Plastic Figures by Farm Factor 3D

Name:"Cowboy Hat Man Long Sleeve"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1042
Category:Cowboy Seated
Material Type:3D-printed Plastic
Finishunpainted


Name:"Cowboy Hat Man Short Sleeve"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1041
Category:Cowboy Seated
Material Type:3D-printed Plastic
Finishunpainted


Name:"Large Man Short Sleeve"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1019
Category:Man Standing
Material Type:3D-printed Plastic
Finishunpainted
Scale Height:6'0"
A product review the NASG web site's webmaster has received indicates that this figure appears to be a bit "fat", without being too overweight. Also, the shoes/feet are of the correct proportional size. This, however, does make the figure unable to stand and its own, so you will likely need to insert a pin in his leg, or glue him down to your layout, module, or diorama.

photo © Farm Factor 3D

Name:"Sitting With Shirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1040
Category:Man Seated
Material Type:3D-printed Plastic
Finishunpainted

photo © Farm Factor 3D

Name:"Sitting With Sweatshirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1035
Category:Man Seated
Material Type:3D-printed Plastic
Finishunpainted


Name:"Standing With Shirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1038
Category:Man Standing
Material Type:3D-printed Plastic
Finishunpainted
Scale Height:6'0"

photo © Farm Factor 3D

Name:"Standing With Sweatshirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1039
Category:Man Standing
Material Type:3D-printed Plastic
Finishunpainted


Name:"Walking With Shirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1036
Category:Man Walking
Material Type:3D-printed Plastic
Finishunpainted
Scale Height:6'0"
A product review the NASG web site's webmaster has received indicates that this figure appears to look healthy, as a hard-working ranch man would be. The shoes/feet are of the correct proportional size. This, however, does make the figure unable to stand and its own, so you will likely need to insert a pin in his leg, or glue him down to your layout, module, or diorama.

photo © Farm Factor 3D

Name:"Walking With Sweatshirt"
Manufacturer:Farm Factor 3D (click for web site)
Manufacturer ID:FF1037
Category:Man Walking
Material Type:3D-printed Plastic
Finishunpainted
Scale Height:6'0"

photo © Farm Factor 3D

Copyright © 2020 NASG, Inc.; all rights reserved